1/4 in. Angle Die Grinder by Steelman

The Steelman 1520 1/4 in. 90° Angle Pneumatic Die Grinder combines hardened spiral bevel gears with ball bearing construction to produce a smooth operating and easy to use hand held power tool. It features a powerful 0.5 HP motor that peaks with a 22,000 RPM free run speed and is controlled with a safety locking tease-trigger for precision control as well as protection from accidental startups. The 1-piece body shell design simplifies maintenance by eliminating leak points and connections that can cause leaks over time. The 1/4 in. collet is set at a 90° angle to the body and is designed to accept a wide range of heads and bits to help you get the job done right with quick-swappable convenience. Highly efficient, the motor runs on a mere 4 cu. ft. of compressed air at 90 psi. The air inlet on the tool’s base is threaded to accept a conventional 1/4 in. NPT fitting or quick disconnect coupler. Tool measures 6.5 in. L and weights 1.5 lbs. letting it get into tight spaces when needed all while not tiring out operators like heavier designs.

• Ideal grinding tool – ideal tool for when you need to remove rust and finishing steel and non-metal surfaces
• Safety trigger lock secures against accidental startup without impairing easy use
• 1/4 in. collet 1/4 in. collet accepts a wide range of heads for a variety of uses
• Free speed – free running speed maximum is 22,000 RPM
• Variable speed throttle for positive speed control via lever style tease trigger
• Reduced maintenance- single piece body shell design minimizes wear points and simplifies maintenance
• Low air demand- operates on a mere 4 cu. ft. per minute of 90 psi compressed air